Click the image below to download the article in PDF format. Does that mean you need to have "loan a van" again for the National. It would be cheaper for me to just buy one outright from Burton which I may end up doing. Here's an idea that I've tossed around: The speedo is not connected but I have a bike speedo fitted. Thursday, 23 June Mockup Time!
With clutch and flywheel it weighed in at 98kg: Same wire as 54 below, I counted it twice. We connected this original coil feed wire to the black plug, wire 57 — which was originally the red air conditioning clutch wire. There a various uprated clutches available but like everything it all costs money! As Andy says you need to cut the tunnel, bulkhead and radiator support panel. Full kit with short remote Wires from the Main Relay Pack:
K series or not - thoughts please | MG Midget and Sprite Technical | mojvrtic.info
Finally a V8 midget forum We also used the diagnostic socket from the donor main loom. Tazio77 Original Poster posts months. What was wanted was a refined conversion that would be relatively simple to install with minimal modifications and no tell-tale signs. Can the cc MG motor be swapped into the car?? So the car's classic look is retained and the chassis isn't weakened. They quote times of 4.
Previous topic Next topic. The photograph shows the initial stages of cutting the cross-member, but this needs to be braced correctly to avoid weakening it. And a roll bar, esp if you're going to compete in it. Modifications to the front cross-member to allow the engine to sit without fouling the sump. Rover Coupe Coldstream, Scottish Borders. My camera battery has run out and I need to get a new phone after my son decided my old one needed to be flushed down the loo!